Akasa PWM Fan Extension Cable | 4-pin Male to Female Connectors | Compatible with PWM and 3-pin Fan | For Computer Cooling Fans and PC Case Fans | 30cm | AK-CBFA01-30

For side panel fan. Extends lead so that it does't come away if I open side panel. Works perfectly.

If you're putting together your own computer, with any luck you'll everything out and it will all fit together perfectly. More often than not, however, you either get so far and realise wires don't reach where they should, things don't fit where you want and there weren't enough of those little screws with that bit thingy on.I was upgrading my front intake fan to a 140mm Apache but the wire just wasn't long enough to reach any of the four pin sockets on my motherboard regardless of how I routed it. I could have made it in an exhaust instead but I was determined to have it as an intake so I ordered this.It's just the right size for what I wanted. If you're trying to do cable management in your PC in order to keep airflow nice and unrestricted, it's worth trying to work out just how much much extension you'll need so as not to buy something far longer than necessary and be left trying to find somewhere to stow all the spare cable away (though still worth being over generous than buying something that ends up too short).Cable is braided so that helps cut down on messy cables in my case. The fitting into which I plug the fan is a little loose and on a few occasions when I've been opening up my machine, the fan has managed to come unplugged from the extension without me knowing which subsequently made me panic when I realised my front intake wasn't working. It's probably better that it comes unplugged easily than be tight and have any accidental tension on the fan cable transferring to the motherboard and bending pins but I would suggest if you use this that you try and keep the section where the two cables fit together easily accessible should you have to reattach them.Overall good, does what you should want it for and is good quality. Just check the length will be sufficient and make sure it's four pin you need and not three pin.

Works as expectedAlthough the braiding feels too cheap to meDon’t have too much to add

Akasa, AK-CBFA01-30 a very well made PWN Fan Extention cable, at the right price.!i PURCHASED THE AKASA 3 Channel Fan Controller, and as I have a very big caseI needed something Decent, to reach far away Fans, because I wanted to controll them andthe Akasa extention cable came up in a search, it was just about the right price, you may wellsee from the picture - if you blow it up or zoom in, its actually very well braded in the factoryfor extra strength, including a lot more ware and tair to boot.!if you have a large case and you have obviously spent a lot of time & money building it as you bought thenecassary parts, the last thing I thought to add - to make it ("Poker Ace's") was the fan controller anda few Different cables by Akasa, including, the 2 into 1 Splitter cables ... which i bought 5 of themand several extention cables, TBH,I bought a few too many; Hopefully, I will use them in another build, they are"black braded cables" for extra ware. I cannot see any better cables from "Scan or Overclockers", I checked."Amazon, - have these cables at the best price; including the best customer service".!! - Thanks, Dave

Does what I needed it to do and good price

Just the job just what I wanted

What can I say about this. It's an extension, it looks good in my fractal design R5 and sorted my need to extend the fan lead so that I could route the cables sensibly. Perhaps a little expensive for what it is.

These are decent quality 4 pin PWM fan extension cables. The cable itself is completely sheathed in a black nylon sleeve which gives it a premium look and feel and the connections fit really well (not loose or too tight).These were just about long enough for what I needed but if you have a very large case then 30cm is smaller than you think!